How to Troubleshoot Car Engine Will Not Turn On

Sometimes there are situations where we can't get the car engine is turned on. If you encounter such a situation should not panic, all you need to do is stay calm and try to find out and fix the problem that occurred. Try you just follow the procedure outlined below.

If the condition of your machine is nice, it’s good, ignition timing and precise, then also a.k.a. needed to switch on the machine with easy is the amount of air and fuel mixture proper spark from plugs as well. In order to produce enough sparks that is determined by the condition of the battery, because the magneto ignition requires very large currents.

Ignition system sometimes not getting enough electric energy so that it often happens where a tough machine switched on suddenly alone can live so the key contact is returned to position ON, while the engine was still spinning.

At the time of the machine breaking down or could not start but can be turned easily by driven, then the first thing to do is check the battery terminal or battery head. In this section there is a sludge that is often on the inside of the connector cord. These deposits should be cleaned with a wire brush or sandpaper. While there is dirt on the outside can be cleaned with warm water.

How to quick test to find out the dirty terminals is by turning the key to start position contact for approximately 10 seconds. Try you touch with your hands, then the terminal is dirty it will feel hot while the terminal is clean, not hot.

On vehicles that are old, the condition can also be the starter Dynamo so the machine does not switch on cause because an old starter will have a fairly high power prisoners so far too absorbing electrical energy very much to play the machines.

Fishing with battery on another car that still fit to turn the ailing car now become way less secure because the computerized system on most new cars do not withstand surges that may occur.

To address this, then both cars must be parked close together but must not come into contact. The positive terminal of the battery to be connected, while the end of the negative cable or grounding cable should not be connected at the battery terminals but must be connected to the engine stalled car close to the magneto ignition.

Once everything is connected, the donor car can now be turned on and gassed to about 2000 rpm before the engine that will be fished. After the car was lured turn on, turn off the engine but leave the engine donors who had turned hard to stay alive and able to turn on all the lights, air-conditioning fan and rear windshield wiper mist. After the reasonably enough, remove the cables connected with reverse order to avoid excess voltage.