How to open tires from Rims and reinstall it

We definitely often have motorcycle tires we're sharing a sudden leak and certainly should be patched or replaced with new tires. Usually we submit fully this duty to clamp the tire repairman, but if forced to, it doesn't hurt us to try to do it yourself.

For opening the outside tires/tubes from the rims do the following procedures:

1. Open the lid nipple, nipple and nut inside the valve amplifier on the rim.

2. Press the part of his bead around the tire, so the tire does not stick or meetings on the rim.

3. Not far from the position of the valve, insert tool or spoon tire lever between the tire bead and rim, then poke the tire with tire spoon directing toward the fingers and hold a spoon tires.

4. Our hands one holding a spoon first and the other hand tires slip a spoon this second ban and not too far from the position of the first tire spoons.

5. Do the same on the perimeter of the bead, the bead to the top of the rim section independently. After this work is completed then remove the ban it.

6. To release the bottom bead then do the same thing as above.


Then to how to install the outside tire/tire rims in back to do the procedure as follows:


1. Install it on the outside of the tires and make sure that the fitting position.

2. Place the outer tires including tires it above the rim; note the nipple should be close and straight to the whole position of the valve on the rim.

3. Point beat down to the middle of the rim, then insert the nipple into the valve hole on the rim position.

4. Enter the entire bead down towards the middle part of the rims with the pressed or with the help of a spoon.

5. To insert a bead above do the same thing as the bottom bead inserts. Note the tire when the top bead has entered more or less semi-circular tires, the rest simply pressed with hands until bead remaining live a little longer.

6. The rest of the bead that little can be inserted with a spoon tires, and check it by emphasizing the tire valve part. Make sure that the tires are especially near the nipple is not pinched by the bead. Complete nipple with amplifier and tighten the valve nut wind.

7. after all of the above work is completed, the new ban that wind and pressure filled the air with customized instruction tire manufacturer in question.

8. Check once again whether the position of the tire that has filled the wind straight or not his position with his rims.