How to overcome Distractions on the ignition system

Indications interference in the ignition system car engine starts with the engine sound limp and difficult life. The inspection is usually done to address it on the distributor CAP or replacement of some components such as spark plug ignition (spark plugs), high-voltage wires, coil and the condenser.

The CAP distributor can have cracks, there's a crust or dew can cause short connection to the car body. Terminal on the distributor CAP can be destroyed by fire, and there is spark plug wiring hole in the dirt. These problems can cause interference on the ignition system.

Spark plug type and electrode distances used must be checked periodically. The effect of the use of an inappropriate spark plug may cause excessive heat which made lubrication up. In addition the electrode plugs will be damaged or broken insulation. Spark plug replacement is usually done after drove car 10,000-15,000 km. The installation needs to be careful not too tight so that the house is not worn or damaged plugs. Use your hands to make a new entry and then put the key to tighten.

Platinum or circuit breaker which is an important part of the series of ignition system can be problematic, for example because of changes the distance gap Platinum. Distance shrinks because platinum liming resulted in ignition occur early. Platinum inspection should be done by routine and measurement of crack Platinum right using Dwell Angel-meters.

After checking or replacing spark plugs and platinum, are usually passed on by checking or replacing the condenser and coils as well as checking the high-voltage cables.